Step 1 – Attaching the Glass Support
1. Clean the glass and the support thoroughly.
2. Glue the glass support using two-component epoxy adhesive, preferably Loctite 3034.
This adhesive does not discolor over time.
3. Apply the glue with a rotating motion to avoid air bubbles between the resin and the support.
4. The engraved KF letters increase the surface area and ensure a stronger bond.
5. Assemble the KlikFiks so that the magnets attract each other.
Allow the adhesive to cure for at least 24 hours before continuing.
Step 2 – Attaching the Wall Support
1. Slide the supports together.
2. Then remove the protective paper from the double-sided tape on the wall support (or spacer).
⚠️ Note: Don't place the second magnet yet – otherwise the magnet will attract too early.
3. Press the artwork onto the desired spot on the wall so that the double-sided tape adheres well and the wall support stays in place.
4. Carefully pull the artwork away; the wall support will now remain attached to the wall.
5. Use a thin pencil or pen refill to accurately mark the screw holes.
6. If necessary, drill the holes and insert the wall plugs.
7. Then remove the double-sided tape from the wall bracket and place the second magnet in the correct position.
8.Cover the magnet with the white sticker so that the magnet does not "stick" to the screws.
Tighten the wall support and any spacers by hand.
Do not use a power drill – this may damage the support.
Step 3 – Attaching the Artwork
If all steps have been followed correctly, you can easily click the artwork onto the wall support.
The magnet provides an extra strong and stable connection.
If the work is large or if the support is not glued in the center of the work, use optional additional supports.